Could not associate wlan0 - try increasing WIRELESS_TIMEOUT and check network is WEP or has no security

# Interfaces to start at boot-up (in this order)
# Declare each interface then list in INTERFACES
# - prefix an entry in INTERFACES with a ! to disable it
# - no hyphens in your interface names - Bash doesn't like it
#
# DHCP: Set your interface to "dhcp" (eth0="dhcp")
# Wireless: See network profiles below
#

wlan0="wlan0 192.168.0.5 netmask 255.255.255.0 broadcast 192.168.0[M [-.255"
eth0="eth0 192.168.1.2 netmask 255.255.255.0 broadcast 192.168.1.255"
eth1="eth1 192.168.0.1 netmask 255.255.255.0 broadcast 192.168.0.255"
wlan_wlan0="wlan0 essid lesnoy"
#wlan_wlan0="wlan0 essid lesnoy key 12345678"
INTERFACES=(eth0 eth1 wlan0)

wlan0 IEEE 802.11 ESSID:"lesnoy"
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Tx-Power=19 dBm
Retry min limit:7 RTS thrff Fragment thr=2352 B
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

wlan0 Link encap:Ethernet HWaddr 00:1E:58:46:A38
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)